2. INSPECTION/ADJUSTMENT Pulsar CK 125 Upper Limit ENGINE OIL Place the motorcycle on its main stand on level ground for oil level check. After the engine is stopped for 10 minutes, check if the oil level is between the upper and lower limits on the dipstick. If the oil level is low, add the recommended oil to the proper level. Recommended Oil: SAE30W# When changing engine oil, be sure to tighten Lower Limit Oil Filter Screen Cap the drain bolt securely. Check the drain bolt washer for damage. Oil Capacity: Full capacity : 1.0 liter At change : 0.9 liter Oil Filter Screen Cleaning Remove the oil filter screen cap. Remove the oil filter screen and spring. Then, clean the oil filter screen with compressed air. Be careful not to install the oil filter Oil Filter Screen screen in the reverse direction to avoid engine damage. Spring Index Mark DRIVE CHAIN Check the drive chain slack. Specified Slack: 12cm Drive Chain Adjustment: 1. First loosen the rear axle nut. 2. Adjust the right and left chain adjusting nuts to align the right and left index marks with the punch marks on the chain adjusters. 3. Turn the rear wheel to see if the drive Rear Axle Adjusting Nut chain slack is within the specified range. 4. Tighten the rear axle nut. After drive chain adjustment, check the rear brake pedal free play and adjust if necessary. 2-7