8. DRIVE AND DRIVEN PULLEYS/ KICK STARTER DINK 50/125 DRIVEN PULLEY ASSEMBLY Clean any oil from the drive belt sliding surfaces on the driven face. Apply grease Filling 12 g of grease to driven face inner side. Apply grease to lips of the new dust seals and install into the movable driven face. Coat new O-rings with grease and install them into the movable driven face grooves. Install the movable driven face onto the driven face. Install the guide rollers and guide roller pins. Filling 5 g of grease to each guide groove. Install the guide pins/rollers. Apply grease Lock Nut Wrench Install spring collar. Use the special tool to install spring and clutch, then install and tighten the nut to the specified torque. Torque: 5.5 kgf-m (55 N-m, 40 lbf-ft) Special tool: Clutch Spring Compressor A120E00034 Clutch spring compressor 8-21