14. FRONT WHEEL/FRONT SUSPENSION STEERING SYSTEM UXV 500 INSTALLATION Apply lightweight lithium-soap base grease to the bearings of the steering knuckle and lips of the dust seal before install the steering knuckle. Install the steering knuckle onto the upper and lower front arms and tighten the nuts to the specified torque. Torque: 3 kgf-m (30 N-m, 22 lbf-ft) Install the cotter pins and band ends of cotter pins. Always use a new cotter pin. Install the tie-rod onto the steering knuckle and tighten the nut to the specified torque. Torque: 2.1 kgf-m (21 N-m, 16 lbf-ft) Install the lock 2 bolts Always use a new cotter pin. Do not apply oil to the seat of the nuts. Do not loosen the nuts after torque Steering Knuckle tightening. If the nuts groove is not aligned with the cotter pins hole, align groove with the hole by tightening up on the nuts. 14-11