7. CYLINDER/PISTON DINK 50/125 Measure the piston O.D. Take measurement at 4.5mm from the bottom and 90° to the piston pin hole. Service Limit: 38.9mm replace if below 4.5mm Measure the piston-to-piston pin clearance. Service Limit: 0.02mm replace if over CYLINDER INSPECTION Inspect the cylinder bore for wear or damage. Measure the cylinder I.D. at three levels of top, middle and bottom at 90° to the piston pin (in both X and Y directions). Cylinder I.D.: Service Limit: 39.1mm replace if over Measure the cylinder-to-piston clearance. Service Limit: 0.1mm repair or replace if over The true roundness is the difference between the values measured in X and Y directions. The cylindricity (difference between the values measured at the three levels) is subject to the maximum value calculated. Service Limits: True Roundness: 0.05mm repair or replace if over Cylindricity: 0.05mm repair or replace if over 7-15