5. ENGINE REMOVAL/INSTALLATION DINK 50/125 ENGINE REMOVAL/INSTALLATION (DINK 125) REMOVAL Remove the air cleaner (refer to the "AIR CLEANER" section in the chapter 13) Remove the carburetor (refer to the "CARBURETOR" section in the chapter 13) Loosen the rear axle nut. Support the scooter securely on its main stand. Remove the three bolts (1) from rear brake hose clamps. Remove the two bolts (2), then remove the rear brake caliper. Disconnect the alternator connector (3). Disconnect the ignition pulse generator connector (4). Release the rubber cap and remove the terminal screw (5) to disconnect the start motor cable from the start motor. 5-2