19. LIGHTS/METERS/SWITCHES DINK 50/125
HEATER CONTROLLER UNIT
(DINK 125 ONLY)
INSPECTION
Heater control unit inspection
1.Open ignition switch to check if the brown
/blue wire of it is enough voltage.
2.Put the heater controller unit in refrigerator.
Start engine after keeping the temperature
under 10 4.
3.Start engine and if the temperature of heater
controller unit is under 10 4. Check if
the white/yellow wire of heater controller
unit has output voltage. If it has not any
voltage. It is damaged.
REMOVAL/INSTALLATION
Remove the luggage box (refer to the
"FRAME COVERS
REMOVAL/INSTALLATION).
Disconnect the controller unit connector (1).
Remove the bolt (2) and heater controller
unit.
Installation is in the reverse order of removal.
19-15
