3. INSPECTION/ADJUSTMENT DINK50/125
Oil strainer screen clean
Change the engine oil with the engine at
normal operating temperature and the scooter
on its center stand to assure complete and
rapid draining.
Let the engine and exhaust system cool
before working in those areas.
1. Remove the oil filler cap/dipstick (1) from
the right crankcase cover.
2. Place a drain pan under the crankcase and
remove the oil strainer screen cap (2).
The spring (3) and oil strainer screen (4)
will come out when the drain plug is
removed.
Let the engine oil drain out.
3. Clean the oil strainer screen.
4. Check that the oil strainer screen, sealing
rubber and drain plug O-ring are in good
condition.
5. Install the oil strainer screen, spring and oil
strainer screen cap.
Oil strainer screen cap torque:
15N-m (1.5 kgf-m, 11lbf-ft)
5. Fill the crankcase with the recommended
grade oil and install the oil filler cap.
Oil capacity (after draining):
DINK125-0.9 liter (0.95 US qt, 0.8 lmp qt)
DINK50-0.7 liter
6. Start the engine and let it idle for 23
minutes.
7. Stop the engine and check that the oil level
is at the upper level mark on the oil filler
cap/dipstick with the scooter upright on
firm, level ground. Make sure there are no
oil leaks.
3-8
