16. CHARGING SYSTEM Pulsar CK 125 PERFORMANCE TEST Perform this test with a fully charged battery. Start and warm up the engine for 10 minutes. Connect the battery positive cable to the ammeter positive probe and the battery negative cable to the ammeter negative probe. Then connect the voltmeter across the battery terminals to test the charging voltage. CHARGING PERFORMANCE: Headlight Charging 3000 rpm 8000 rpm Switch rpm OFF (Day) 2150 rpm 4A 16V 6.3A 16.7V max. ON (Night) 2150 rpm 1.1A 14V 2.1A max.) 14V max. (1.0A min.) (3.7A LIMIT VOLTAGE TEST: Start the engine and gradually increase the engine speed to measure the limit voltage. Limit Voltage: 14.70.4V Note: Test when the battery is fully charged. When testing the limit voltage, use a tachometer for operation. A.C. GENERATOR Pink Yellow REMOVAL Remove the A.C. generator. (Refer to 8-2.) INSPECTION Disconnect the A.C. generator pink and yellow wires and measure the resistance between the pin and yellow wires. Resistance: 0.2 Do not ground the A.C. generator pink and yellow wires. 16-5