3. LUBRICATION SYSTEM Pulsar CK 125
Right Crankcase Cover Bolts
OIL PUMP
REMOVAL
1. Remove the kick lever.
2. Disconnect the clutch cable.
3. Remove the right crankcase cover bolts
and right crankcase cover.
4. Check the cover gasket, oil seal and O-ring
for oil leaks or damage. Replace with new
ones if necessary.
When installing, make sure to use a new
right crankcase cover gasket.
Screws Nut Socket Wrench
Remove the three screws attaching the oil
filter rotor cover to remove the cover.
Remove the oil filter rotor lock nut with a
square socket and then remove the washer
and oil filter rotor.
During installation, install the washer
with the mark "OUTSIDE" facing up.
Oil Filter Rotor Cover Lock Nut
Oil Pump
Remove the two oil pump mounting bolts
and the oil pump.
Remove the two O-rings.
Bolts O-rings
O-rings
Check the two O-rings for wear, damage or
deterioration and replace if necessary.
3-3
