8. STARTER MOTOR/GENERATOR/LEFT CRANK-
CASE COVER/STARTER CLUTCH/CAMSHAFT Pulsar CK 125
Groove
LEFT CRANKCASE COVER
INSTALLATION
Install the left crankcase cover and tighten
the eight bolts. (Refer to 8-2.)
Torque: 0.81.2kg-m
Install the reduction gear, shaft and washers. Bolts Shaft Reduction Gear O-ring
Then install the reduction gear cover and
tighten the three bolts.
Torque: 0.81.2kg-m
· Install the reduction gear shaft by
aligning the shaft pin with the shaft
seat groove.
· Apply engine oil to the reduction gear
cover O-ring before installation.
Pin Washers Cover
O-ring
STARTER MOTOR INSTALLATION
Apply engine oil to the starter motor O-ring
and then install it.
Install the starter motor.
Install and tighten the two mounting bolts.
Torque: 0.81.2kg-m
Starter Motor Mounting Bolts
8-6
